Task No 13 - Vehicle Inspection - Tuesday 19 May 2015

Plan

Undertake inspection and test of 4 Post Ramp prior to vehicle loading.  Load vehicle and undertake inspection as per current regulations and criteria and report findings.

Task Requirements

• Inspection & Report
• Emissions Test
• Tyre Tread Depths
• Foot Brake Performance
• Hand Brake Performance
• Complete Knowledge Questions
• Complete Blogger
• Report to Assessor with Analysis and Diagnosis
• Account for all tools and equipment.
• Clean and Tidy Work Area.

Analysis

The inspection was performed following the provided check sheet, and the following observations recorded:

Wipers/Washers 

OSF Jet blocked - Washers do not provide enough liquid to clear screen in conjunction with wipers (6.1.3)

Doors

OSR Door does not open from inside (6.5.5)

Registration Plates

Vehicle Registration Plates absent from front and rear of Vehicle (6.8.1 a)

Headlamp Aim

Headlamp Setting 1 %

Headlamp Aim of the NSF was too high (1.6.1)

High Beam Pattern

Steering

OSF Track Rod Loose (including split gaiters) (2.2.c)

Brakes

Imbalance was noted to NSR handbrake.

Diagnosis

Due to the faults identified above, a pass certificate can not be issued for this vehicle, until the faults have been rectified, and a further test subsequently conducted.

Task No 11 - Faults in Steering System

Plan

Task Commenced:  Tue 5th May 15.

Gather all tools and equipment and retrieve vehicle information for entry onto Job Card.  Conduct an inspection and test of the 4 post ramp prior to vehicle loading.  Crack front wheel nuts and raise front of vehicle on beam jack.  Remove front road wheels and track rod ends and report. Reinstate track rod ends and road wheels, lower beam jack and torque road wheels to manufacturer's specification.  Undertake 4 wheel alignment using Hawkeye Aligner.

Task Requirements

• Remove and Re-fit Track Rod Ends.
• Undertake 4 Wheel Alignment.
• Complete Knowledge Questions.
• Complete Blog.
• Report to Assessor with Analysis & Diagnosis.
• Account for all tools and equipment & tidy work area.

Analysis - Track Rod Ends

Track rods and ends were disengaged from steering knuckle.  Track rod ends were wound off whilst counting the number of turns respectively. 

NSF Turns: 17

OSF Turns: 16

Rubber boots to both ends were badly split and both stems displayed excessive levels of play.

Split Boot

Diagnosis

Due to the extent of splitting to the respective boots, the excessive levels of stem play and the unknown amount of time of exposure to the elements and debris, I would recommend ordering 2 new track rod ends, rather than just replacing the boots.  There was also an inbalance in the number of turns of the track rod ends noted at removal.  In such circumstances it is recommended that the amounts of turns are added together and then halved and evened accordingly.  16+17= 33.  Round down to 32 and divide by 2 = 16 turns back on for both track rod ends.  The vehicle should now also undergo a wheel alignment accordingly.

The Garage - Friday 15th May 2015

1991 VW Transporter

Today I was assigned an electrical fault (lighting) task on a 1991 VW Transporter/Camper Van.  The vehicle has been at the garage for about 3 weeks, as the fault has proved very elusive to all who have attempted, and priority work loading has since prevented further progress.  This was my second attempt, as the first involved checking all the fuses and relays and the replacement of the left hand "Main Beam/Dip" column stalk, which was originally thought to be the cause of the fault.  There was originally evidence of a broken contact on the original component, however upon its re-assembly the fault of "no main beam/dip" remained.





Due to the level of work being undertaken inside, I was required to undertake the task outside in the bright and warm sunshine (ah well)! This also brought to the front of my mind the probable pining for the vehicle by the customer for the imminent Summer months, which spurred me on to solve the issue this time around!

Column Shroud
Removed

Having first removed the steering column shroud, I then 
proceeded to remove the horn switch to expose the steering wheel securing nut.  With the nut removed I was able to remove the steering wheel and expose the first of the 2 column stalks.  This was the component that was replaced last time around, and as far as any previous disassembly had gone.  Andy had instructed me to remove both stalks this time, and be particulalry vigilant in observing any broken or corroded wires and contacts in the process.

2nd Stalk exposed

Steering Wheel
Removed

Contact at 6 Oclock
originally damaged

Electrical Connector
Examined & Removed

It was at this stage I noticed that a connector on the 2nd stalk was only partially connected, which I duly noted on my Job Card for bringing to the attention of Andy at de-brief.  With all connections fully removed I was then able to remove the 2nd stalk, leaving the steering column stripped as far as the job required.

Partially engaged
connector

2nd Stalk Removed

Stripped Column

I then reported my findings to Andy who instructed me to re-assemble the components without attaching the steering wheel, ensuring all connectors were fully engaged, and then call him again to undertake another test of functions.

Happy Friday!
Which way to
Zone 2 please!

With all carefully completed Jim came out and observed a test of functions - which I am pleased to report was an outstanding success!!  With fault recorded as loose connector, it was then just a case of re-attaching the steering wheel with a high torque setting (ensuring that the road wheels were as straight as possible), and then reconnecting, inserting and testing the horn switch (which I did several times with a big smile)!  I was then requested to bring the vehicle to the front of the Workshop in order for it to undergo an MOT re-test and a subsequent front wheel allignment.  This was unfortunately the time that I was required to depart for my evening location, however it was a very satisfying and busy day which I enjoyed thoroughly!

Visit to Oulton Park - Tuesday 12th May 2015

Had a fantastic day out today with the College, and the Sun came out too! We visited Oulton Park Race Circuit, which was a most welcomed break from our previous years studies.  We arrived at College at 9 am (mostly) ready to be counted and then awaited the arrival of our transport, which was scheduled for departure at 10 am.  With all heads counted and the minibus present, we were duly escorted off to Oulton Park Race Circuit under the supervision of Kev "the college stig" Rogers (as he was affectionately named), even though the minibus was speed limited.  There was suggestion on the way that Kev should take the College Chariot onto the circuit for a bit of "drifting", however I am pleased to report that eventuallity did not manifest itself!

Level 3 Crew
De-bused

This was another first for me, even though I spent most of my school years living a stone's throw away from Thruxton!  The days' attraction was road cars on a track day, and there were some outstanding examples of performance tuned and balanced vehicles taking part (one in particular made my day, and one in particular made Wendy's)!  After a quick comfort break and a caffiene shot at the cafe (ouch), we set off to find a good vantage point to capture some photographs of the cars being put through their paces.

My reactions were nowhere quick enough to capture any detailed photographs of the cars in action, however we were granted exclusive access to the pits at the circuit stand down, and managed to catch up with the crews and have a closer look at the cars, which was awesome!  I

Austin

eventually caught up with my favourite, which caught me completely by humoured surprise in performance testing, as it was the very last car I expected to see cutting along at a "very" respectable pace with the others.  I have a great video on my phone which I will treasure for evermore, and as soon as I find a way of getting the video on my phone compatible with Blogger, it will be included!

E-Type Jaguar

There was one other car that caught my attention, and that was an E-Type Jaguar.  Absolutely "mint" condition also, and how the heck those drivers have the kahoonas to drive them at such a pace without fear of giving them a "ding" is beyond my comprehension!

E-Type Engine!

After chatting with the crews' of a few more of the other cars it was unfortunately "time up" for us all, and back to the bus we all duly headed for the short journey back to college.  Big thanks to Kevin for his guidance and driving, and also to Carl Roberts for making the event possible in the first place - very much appreciated, and thanks again!